How to connect pin with buspirate 3.6

Im just get confuse how to connect MX25L6406E with buspirate on pin 3,7,8? They are connected with 3.3v but on buspirate only have one 3.3v pin.

Thanks in advance

Cr BP-Pinout from thaGH05T

**Edit due to Wrong photo

pin 8 is a VCC and should be connected to 3.3v
pin 3 is a WP it can be connected to 3.3v to disable write protection. pin 7 is a HOLD/RESET. HOLD signal should be high for any operation with chip. If you perform an in-circuit operation then high level may pass to pin 7.
So, you should connect pin 8 to 3.3v to chip power supply, and leave pin 3 and 7 opened but keep in mind that the HOLD (pin 7) must be high and if buspirate can't detect a chip just connect pin 7 to 3.3v too.

Hi all, How about make jumper from pin 10 on bus pirate to connect to pin 3, 7, 8 on the chip?

Also, i dont think Pomona 5250 test clip for SOIC 8 pin will work in this case due to very tiny chip legs on mainboard.(macbook pro retina late 2013 i5 2.6 EMC 2678, MX25L6406E)