- Posts: 5
- Thank you received: 1
Forum Login
Did anyone of you succeed to flash a MBP A1502 ?
Rendering Error in layout Widget/Social: Call to a member function exists() on null. Please enable debug mode for more information.
6 years 9 months ago #7318 by hex
Did anyone of you succeed to flash a MBP A1502 ? was created by hex
Hello there,
First of all thanks for your work. This forum is amazing !
I'm trying to flash a MacBook Pro A1502 EMC :2678, but it give me hard time.
I searched in the forum for a solution but I didn't find anything so I'm opening a new topic.
I'm using an Easy flash 4.0.2 with a raspberry pi 3.
I tried with the battery without the battery with the magsafe and without...
Every time I try I get this message :
So I started to think something was broken...
But I tried with my Macbook air to test if my setup what good ( same Easy flash chip same setup ) and it worked ! I read erased and wrote easily !!
So I don't understand what don't work with the MBP...
Have you any idea ?
Thank you
First of all thanks for your work. This forum is amazing !
I'm trying to flash a MacBook Pro A1502 EMC :2678, but it give me hard time.
I searched in the forum for a solution but I didn't find anything so I'm opening a new topic.
I'm using an Easy flash 4.0.2 with a raspberry pi 3.
I tried with the battery without the battery with the magsafe and without...
Every time I try I get this message :
sudo flashrom -p linux_spi:dev=/dev/spidev0.0
flashrom 0.9.9-33-g026c741 on Linux 4.9.35-v7+ (armv7l)
flashrom is free software, get the source code at https://flashrom.org
Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.So I started to think something was broken...
But I tried with my Macbook air to test if my setup what good ( same Easy flash chip same setup ) and it worked ! I read erased and wrote easily !!
So I don't understand what don't work with the MBP...
Have you any idea ?
Thank you
Please Log in or Create an account to join the conversation.
