what wrong with read chip via raspberry pi

bestfood wrote: Hi all, does anyone can tell me what wrong with me. I could not read a chip I think I connect to the right pin boy not really sure about command line.

Thank you

manny-goldberg wrote: Hi, I have the same model (more or less, logic board model 8203476-A) and the same problem spit out by flashrom, but instead of using the header and ghost's device to interface with the logic board I am using the pomona SPI clip. It attaches firmly to the MX25L6406E EFI chip on the inner side of the logic board, right underneath the header. However, I am not sure the metal parts are making contact with the clip, they are very tiny and I can't even imagine having to do soldering.

Also, I have a pi model A+ (pretty old but only one i could find).

1. Try and run the below command while connected to the chip.
2. Make sure your pi is plugged into a 2a power supply.
3. Make sure your wires are less than 20cm; 10cm is best.
4. Make sure if you are using the MBA Easy Flash that it is on pinout 1.

sudo flashrom –r ~/efi/read1.bin -V -p linux_spi:dev=/dev/spidev0.0